Error code 202
LINAK overcurrent
Alarm at Drill and Maestro.Drill (202-1)
since version 10.10
Maestro (202-2)
since version 10.10
When does the alarm occur?
Overload of section control motor.
It is shut off for protection.
It is shut off for protection.
Does a Drilling error (drilling drop-out) occur?
Yes!
What to do?
- Check half-width flap for blockage or damages.
- Remove any blockage that may be present.
- Replace flap if damaged.
- Check correct function of half-width flap after problem has been corrected.
- From SW version 10.11:
- Explicit note through popup. Check half-width flap for damage and clear blockage. Replace or repair flap if damaged. After this the teach values and positions of the half-width flap must be absolutely checked. The drill function main switch must be activated again on its own.
Is there an audible indication?
3 successive acoustic signals
How is the alarm confirmed?
Press ESC to confirm
Terms of use
Note: The assistance operations given in the present application may only be carried out observing the safety notes in the operating instructions of the corresponding machine. Compensation claims for damages due to non-observance of the operating instructions are excluded.